Tutorials Find step-by-step instructions for completing tasks with NI products.

Showing 1-10 of 4,862 results

What's New

Performing System Calibration - mmWave OTA Validation Test Reference Architecture

Use the RF System Calibration Assistant to perform a full system calibration on all the mmWave OTA Validation Test Reference Architecture hardware components. NI recommends performing system calibration ...

Getting Started with Step-by-Step Position Sweeping - mmWave OTA Validation Test Reference Architecture

With step-by-step position sweeping, sweeping is exclusively controlled by the test execution engine which consumes a list of predefined positions and sequentially performs a measurement at each point. ...

Connecting Internal RF Cables - mmWave OTA Validation Test Reference Architecture

Connect one end of two 2.4 mm (m)-to-2.4 mm (m) cables to the interior chamber rear bulkhead 1A and 2A ports. Route the opposite end of the cables through the correct locations on the positioner, as shown ...

222aaa·com男人天堂